Objective

To enable Auto Mode (Presentation Mode) so the scanner will enter Auto Mode when placed in Socket Mobile’s Charging Stand.

 Setup

• Retail POS on iPad
• For Socket Mobile Scanner models CHS 7Qi & 7Xi 

Steps

Remove the scanner from your iPad Bluetooth settings:

1. Open your iPad Settings App
2. Tap Bluetooth
3. Tap the 'i' next to the device name
4. Tap Forget device

Unpair the device and resetting to factory default:

1. Press and hold on the two buttons on the scanner for 3-4 seconds until you hear three beeps

2. You can print the Barcode below and scan it to reset the Barcode scanner to factory settings

Enabling Auto Mode:

1.  Ensure the Socket Mobile Scanner is unpaired 
2. Once disconnected scan this barcode to enable Auto Mode 
3. Once Auto Mode is enabled by scanning the barcode above reconnect the scanner to Retail POS as  per the setup guide

Additional Information

• Setting up my Socket Mobile Scanner for iPad